Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet!
The Power-All provides 9 volts DC at 2000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The PA-9B Power-All Basic Kit can power five pedals out of the box, and comes complete with a variety of jumper cables that allow connection of phone plug, reverse polarity, digital, and battery-only pedal types. New Ten-Foot, 18-gauge output cable allows for longer power runs without the need for an extension cord.
The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum. The PA-9 automatically converts any input voltage to 9 VDC, allowing it to be used anywhere around the world!
Built to stand the rigors of the road, the Power-All features professional-grade construction and comes with a lifetime warranty – if anything ever goes wrong, simply contact the manufacturer and they’ll replace the unit FOR FREE!
Features:
Power-All 9 VDC, 2000 milliamp digital power supply
LIFETIME WARRANTY – never buy another power supply!
Power all your pedals from a single power supply
Takes up only one outlet space
Replaces Boss PSA-120, DOD PS-200R, Morley 9V, DanElectro DA-1, Dunlop ECB-003, Ibanez AC- 109, Guyatone AC-2, Maxon AC210N, Zoom AD-0006 and just about any other 9 VDC power adaptor
Special, low-noise circuitry reduces ripple current and hum
Powers 9 VDC effects from any electrical outlet in the world
Cable-5/R five-connector right-angle Daisy Chain with spring-loaded jacks for extra secure connections – no more losing power mid-solo!
(1) Cable-Blue 3.5 mm Phone Plug Jumper Cable for EH and other vintage pedals
(1) Cable-Green Line-6 Jumper Cable with spring loaded jack for use with Line 6 Modelers and other pedals requiring a 2.5 mm internal diameter jack
(1) Cable-Grey Battery Clip Jumper Cables for pedals with no AC input
(1) Cable-Red/R right-angle Reverse Polarity Jumper Cable with spring-loaded jack for powering tip positive pedals
(3) Cable Cap insulator sheaths to cover power leads when not in use
|
|
|
 |
